rec.arts.movies.production.sound

the jvc is about the best hdv recording camera i worked with
the metering system is terible as each dot is 4 db
also there are 2 line levels ref you should work with -20 ref as it support
+ 4db signal
the -12 support lower consumer level
if you have lectrosonic tx , open the ton on your reciever and the fader
till your mixer will glow + 20 db
then calibrate the camera meter will hit the red , go bit back , you done
the headphones at least on 101 distort at + 16 dbu
the lne level on 101 was noisy so better not to use
work normaly that your picks will hit at least + 10 dbu
"rraudio" wrote in message
news:749a2822-5aca-4036-9b11-e3cc36c0fdf3@...
>I have some projects coming up with an JVC GY-250HD. Anyone worked
> with these before.. What should I expect?, Levels? .. +4 or OdB, using
> a SD-442 for hardwire interviews.
> I see via the PDF manual there is HP filter (among other parameters)
> via the software menu. I wonder if this defaults to the factory
> settings like some of the Sonys, when it's shut down?
> Is there a good place to hang a receiver or two on it? If not, where
> would I get a bracket like some that are available for the small
> Panasonic & Sony cams.
> Thanks, RR